Inspect a Forklift
There are over 10,000 workplace injuries connected to forklifts occur each year, according to OSHA and HRSDC reports. A lot of these accidents are caused by driver error. Lack of proper equipment maintenance and inspection causes many others. Forklift maintenance and operation is not only the cause of personal injuries, but also of property damage. Forklifts could damage overhead pipes, sprinklers and building structures, and other machinery when operated incorrectly. The following daily check ups should be carried out so as to reduce the possibility of forklift mishaps.
Turn off the engine prior to checking different fluid levels: engine oil, fuel, hydraulic oil, coolant and brake fluid. The tires should be checked for indications of wear and tear. Check the tire air pressure. Check the forks' condition. The load backrest need to be attached firmly. Do a visual inspection of the top-clip retaining heel and pin. After that carry out an inspection of the hydraulic hoses, mast chains, stops and cables. Ensure that the overhead and finger guards are attached firmly.
The LP powered forklift has propane tanks which need to be checked for corrosion, damage or rust. The battery's charge and electrolyte levels have to be tested periodically. Seat belts have to be checked for wear and tear. Check to make sure the owner's handbook is kept on-board the forklift in a storage compartment. Check the seat belt to make sure the latches are secure. Test the hood latch to ensure it is working as it should.
To make sure there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate immediately. Check the accelerator and the steering controls. The service brake and the parking break should be correctly working.
The drive control and tilt control must be inspected to guarantee proper functioning in both forward and reverse. Check the functioning of the lowering control and hoist, and the attachment control. Check the horn and lights. Afterward check the wipers, heater and defroster to make certain they are functioning well. Inspect each gauge to ascertain that it is reading within functional limits.