In nearly all cases, most individuals spend quite a lot of money buying their forklift. Hence, it is very important to take good care of it so as to protect your investment well into the long run. It is really a great idea to know the procedures that are carried out during the care and maintenance of this piece of machinery.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is running. For instance, if there are any misses or knocks, the equipment is faulty and this must raise some concerns. In addition listen carefully for any squealing sounds that come from the belts since these sounds would provide you with a lot of information.
When carrying out maintenance, several of the main parts you would need to pay attention to comprise the safety warning devices, horn, the overhead guard, the lights and the gauges. Any faulty components or burnt out light bulbs should be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals should be cleaned when the above parts have been inspected carefully. If the terminals are not clean, be sure to clean them properly. Each and every cell of the battery has to be inspected in order to make certain that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the equipment and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters should be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
After the oil change is carried out and the filters have been replaced, a visual inspection of the drive axle has to be performed. If there is a grease fitting on the axle make certain to apply some grease. Check the belts on the engine for any frays or cracks. If you find any, fix the issue accordingly. Then, check every other component of the machine like the wheels. If any kind of fault or concern is detected, be certain to deal with it immediately so as to make sure the machine is running at its safest and optimum levels.